|
Construction
Surface mounted liquid soap dispenser is fabricated of durable, high impact resistant, grey ABS with high gloss finish on exposed surfaces. Soap head holding capsule valve has stainless steel spring, u-packing seal, and duckbill. Container has concealed locking device to secure lid and is keyed like other Bobrick washroom accessories. Capacity: 50 oz.
Installation
Provide (3) #10 x 1-1/2" (4.8 x 38mm) sheet metal mounting screws to mount the container on wall at points indicated by
an S. For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure unit
with sheet metal screws. For other wall surfaces, provide fiber plugs or expansion shields for use with sheet metal screws, or
provide 1/8" (3mm) toggle bolts or expansion bolts. For mirrors or glass surfaces, use pressure sensitive tape strips furnished
by manufacturer: clean glass, apply both tape strips horizontally to back of container, press container onto glass surface, then
allow the tape to set 24 hours before filling with soap.
Note: Mount dispenser plumb and true with valve 6" (150mm) to right or left of lavatory center. Provide 6" (150mm) minimum
clearance from lid to underside of any horizontal projection for top filling. Push buttons should be located 44" (1120mm)
maximum above the finish floor.
Operation
Soap is manually dispensed by pushing against valve push button. Valve operation complies with ADA Accessibility Guidelines by requiring no more than 5 lbs. pressure to actuate and requires no grasping or twisting by operator. To fill container, push furnished key down into slot at back of lid and lift off lid. To close the lid, hook bottom front of lid into recessed area located inside top front of container and rotate back of lid toward container. A snap will be heard when the lid is locked.
Warranty
One (1) Year Manufacturer's Warranty - Warranted to be free of defects in material or workmanship for one (1) year from date of sale.
|