Channel Frame Mirror frame is fabricated of type 430 stainless steel, one piece frame with 90 degree mitered corners. Galvanized steel back has integral horizontal hanging brackets near the top for hanging the mirror and near the bottom to prevent the bottom of the mirror from pulling away from the wall.
Mirror standard glazing is No. 1 quality, 1/4" (6.4mm) thick float glass, selected for silvering, electrolytically copper-plated by the galvanic process. It is warranted against silver spoilage for 15 years. The back is protected by full size, shock absorbing, water resistant, nonabrasive, polyethylene padding.
The exposed frame surfaces have a bright polish finish.
*Bobrick framed mirrors are not field interchangeable from horizontal to vertical or vice versa. For custom mirror sizes email: firstname.lastname@example.org with size and mirror type.
Mount wall hanger on wall with screws (not furnished) at points indicated by an S. For plaster or dry wall construction, provide
backing to comply with local building codes, then secure wall hanger with screws (not furnished). When providing a concealed
backing, allow backing to cover minimum range of mounting hole locations shown on drawing. For other wall surfaces, provide
fiber plugs or expansion shields for use with screws (not furnished), or provide 1/8" (3mm) toggle bolts or expansion bolts.
Snap Locking Design: Hang mirror on wall hanger with all four backplate louvers engaged behind horizontal wall hanger members. To do this, mirror
must be centered in front of the wall hanger horizontally, pressed flat against the wall approximately 1" (25mm) above final
position and then lowered into final position.
"2S" Tab Design: Comprises of two brackets, while the bottom one is furnished with double side tape. Bottom hanger
bracket's mounting holes must be 1" - 1 1/2" above mirror's bottom edge. Note: Bottom hanger bracket is not supposed to
engage with louvers of mirror's backplate. Hang mirror on wall top hanger bracket with the top two louvers engaged behind top
wall hanger bracket. To do this, mirror must be centered in front of the wall hanger horizontally, pressed only at the top against
the wall approx. 1" (25mm) above final position an then lowered into final position. When lowering, pull mirror's bottom edge
off the wall by preventing bottom bracket from engaging. Once lowered, mirror must be pressed against wall to engage with
double sided tape of lower wall hangar bracket.
Snap Locking Design — Locking devices automatically secure mirror to concealed wall hanger when it is lowered into final
position. Locking devices may be unlocked by inserting two flat blade screwdrivers behind each side of mirror
near the bottom or under the bottom of the mirror and pulling mirror bottom forward and then up.
"2S" Tab Design — Secure mirror to concealed wall hanger by pressing mirror against double sided tape of lower hanger
once it is lowered into final position.
For compliance with ADA Accessibility Guidelines install unit with bottom edge of reflecting surface no higher than 40" (1016mm) maximum above finished floor. Note: Consult local and national accessibility codes for proper installation guides. Code compliance is the responsibility of the installer.
Fifteen (15) Year Manufacturer's Warranty - Warranted against silver spoilage under normal indoor atmospheric conditions from date of sale.