ASI 3451-25 Swing-Up Grab Bar - Division 10 Direct

Home > Grab Bars > Swing Up/Away >

ASI 3451-25 29" Swing Up Gravity Lock Grab Bar 1-1/4" OD, Toilet Tissue Holder

List Price: $687.60

Our Price: $378.20

Savings: $309.40

Manufacturer: ASI
Availability: Usually Ships in 3-5 Business Days

Product Code: 3451-25

Qty:

Description

Technical Specs

ASI 3451-25 29" Swing Up Exposed Mount Gravity Lock Grab Bar 1-1/4" (32mm)OD with Toilet Tissue Holder, Satin Finish

Construction
Swing Up Grab Bar shall be fabricated of type 304 stainless steel alloy 18-8. Tubing is 1-1/4" diameter x 18 gauge. Mounting Bracket shall be 7 gauge plate with six (6) 5/16" diameter mounting holes provided. Bar shall have 1-1/4" diameter tubing hinge and shall have a solid bar axle with twin torsion spring counter balance. All exposed surfaces shall be satin finish. Structure shall be of welded construction. All exposed edges and corners shall be eased and burr free. Vertical position gravity lock with manual release shall be provided. Tamper resistant set screw shall be provided to allow owner to lock grab bar in vertical position. Internal mechanisms shall be captive and suitable for heavy duty service. Grab bar shall be operable with no more than 5 lbs and only one hand. Grab bar tube shall have a plastic end cap to cushion contact with wall plate in use position.

All Exposed Surfaces are Satin Finish Stainless Steel. Optional non-slip peened Surface denoted on part number with -P (peened).

Installation
Installer/construction contractor must provide concealed anchor plate or blocking as specified in construction documents or as required by local building codes prior to wall finishing. Fasten wall plate to concealed anchor or blocking plate with appropriate hardware (by others). Note: concealed mounting plates or anchors and hardware are not supplied with this product.

For compliance with 2010 ADA Accessibility Standards install unit so that the top of the grab bar is 33" minimum above finished floor (AFF) to 36" maximum AFF.

ASI grab bars are designed to meet and exceed 2010 ADA Accessibility Standards and ANSI A117.1 that fabricated product shall be of adequate strength to support a load of 250 lbs when properly installed. Mounting to the wall is a critical part of the system to meet this requirement. The fastener system must be adequately sized to withstand the shear, tension or pullout, and torsion loads generated by the maximum loading, the fastener system must be adequately sized.

Operation
Swing Up Grab Bar is lowered manually to horizontal position for support and raised for departure or arrival. Gravity lock prevents grab bar from dropping from the vertical position, and must be manually released to lower grab bar. Lock does not affect raising bar from horizontal and automatically locks bar when bar is returned to vertical storage position. It is the owner's responsibility to ensure continued safe operation by performing periodic inspection and effecting any adjustment or repairs required as usage may loosen tension over time. Plastic tube cap closes end of bottom tube and provides smooth solid contact with back plate.

Warranty
One (1) Year Manufacturer's Warranty - Warranted to be free of defects in material or workmanship for one (1) year from date of sale.